A Dalton company - serving Miami, FL

Rheem Heat Pump Installation Nationwide | Dalton Heating & Air Miami

Furnace & heatingFurnace & heating
AC repairAC repair
Heat pumpsHeat pumps
CarrierCarrier
TraneTrane
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

Your new heating and cooling system for as low as$119/month*On approved credit; ask for current terms

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Rheem Heat Pump Installation in Miami: What to Know First

We install Rheem heat pumps across Miami as an independent Rheem service provider, and most jobs go from first call to cold air in two to five days. The honest price posture is this: a Rheem heat pump installation in Miami runs $4,130 to $8,850 depending on the model line, your home’s ductwork, and whether we’re doing a straight swap or a full system replacement. You get the written price before any work starts, and the installation carries our full-year Done Right Promise. If you own a Rheem and you’re weighing repair against replacement, call (850) 754-6042 and tell us what it’s doing. We’ll tell you what it costs. In writing.

Call (850) 754-6042

This page is for Miami homeowners who already have a Rheem heat pump, are considering one, or just learned their existing unit is done for. It covers what actually fails on Rheem equipment in our climate, what a proper install looks like, and what you should expect to pay.

How Rheem Products Fail – and How We Fix Them

Rheem builds solid equipment, but Miami’s heat and humidity push every heat pump harder than most of the country. Here’s what we actually see on service calls and installations in this market:

  • Rheem RP14 and RP15 compressor contactor pitting. These are workhorse single-stage units, but the contactor (the electrical switch that fires the compressor) takes a beating from Miami’s constant cycling. Pitting on the contacts causes intermittent failure that reads like a dead capacitor. We replace the contactor with an OEM part on most installs to keep the warranty intact and save the homeowner a callback.
  • Rheem Prestige and Classic series defrost board failures. In Miami’s humid shoulder seasons, the unit runs enough heat at night to trigger defrost cycles. A failed defrost board can ice the outdoor coil even at 50 degrees. It looks like a refrigerant problem. It’s usually a $200 board, not a compressor. We check the board before quoting anything bigger.
  • Reversing valve sticking on Rheem two-stage units. The reversing valve is what flips the system between heating and cooling. On older Rheem two-stage heat pumps, the valve sticks mid-shift and the unit heats when it should cool. It’s a known wear item, and replacement is a few hours of work. We always test the valve under load before condemning the compressor.
  • Evaporator coil corrosion from Miami’s salt air. Even inland Miami gets enough airborne salt to eat copper-aluminum coils faster than the manufacturer’s average lifespan tables suggest. Homes in Coral Gables and Coconut Grove are worst. We see five-to-seven-year-old Rheem coils with pinhole leaks. On a replacement, we push aluminum coils and confirm the drain pan slope handles our monsoon-season condensate load.
  • Blower motor run capacitor failures on Rheem air handlers. The air handler is the indoor half of the heat pump. Its blower motor capacitor is cheap, but when it weakens, the motor runs hot and the coil ices over. We replace weak capacitors during installation rather than wait for the motor to burn out. A $40 part beats a $400 motor every time.
Explore

Styles & brands we work with

AC repair
AC repair
Furnace & heating
Furnace & heating
Heat pumps
Heat pumps
Carrier
Carrier
Trane
Trane

Our Rheem Heat Pump Installation Process

Here is exactly how a Rheem install goes with us, start to finish:

  1. 1
    You call and a person answers. We answer live, 24/7. You describe the problem, we schedule a window, and we arrive inside it. Marco Benitez and the crew run service calls across Miami and Coral Gables, so we know the neighborhoods and the parking situations.
  2. 2
    We diagnose the existing system. We test static pressure, check refrigerant charge, measure amp draw on the compressor, and evaluate the ductwork. Static pressure is the resistance to airflow in your ducts. High static pressure kills heat pumps faster than anything else in Miami, because the blower works harder and the coil gets too cold.
  3. 3
    You get a written price. Before any work starts, we put the full install cost in writing. That includes the equipment, the electrical work, the pad or stand, the line set if needed, and removal of the old unit. The price you see is the price you pay.
  4. 4
    We do the install by the book. That means a nitrogen purge during brazing, a deep vacuum pulled to below 500 microns, and a proper charge weighed in to manufacturer spec. We use OEM Rheem parts where the warranty requires it, and quality aftermarket parts where it makes more sense for the homeowner’s budget. We explain which is which before we proceed.
  5. 5
    We test under load and walk you through the system. The unit runs in both heating and cooling mode before we call the job done. We show you the thermostat, explain the filter size, and leave the job site clean.
  6. 6
    You get the Done Right Promise. Our installation carries a written guarantee for a full year. If it fails in that time, we come back at no charge.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

What Rheem Heat Pump Installation Costs in Miami

Expect these ranges for Rheem heat pump work in Miami. These are real numbers based on what we quote in this market, not national averages pulled from a website.

  • Straight swap, same size and location: $4,130 to $5,900. Existing ductwork stays, electrical is adequate, and the line set is reusable.
  • Full system replacement with air handler: $5,900 to $8,850. New indoor unit, new refrigerant lines, updated electrical, and often a new thermostat.
  • Repair on a Rheem heat pump: $175 to $765. This is the range we quote for most repair scenarios. If the repair pushes past the halfway mark toward replacement cost, we’ll tell you straight.

What moves the price: your home’s square footage, the SEER rating you choose, whether we’re running new electrical, and whether your existing ductwork passes a static pressure test. Every quote is free. Call (850) 754-6042 and we’ll give you the number in writing.

Why Miami Homeowners Call Dalton Heating & Air Miami for Rheem Work

We’re a Garrison Partners company, which means we operate under The Garrison Standard: arrive inside the window, put the price in writing before starting, do the job by the book, leave the site clean, and stand behind the work for a full year. That standard has been in place since 2003. Our techs are factory-trained on Rheem and eight other major brands, including Carrier, Trane, and Lennox, so when a Miami home has mixed equipment, we handle the whole system without calling a second company. The written guarantee on every repair is not an upgrade or a upsell. It’s included. If the repair fails during the guarantee period, we return at no charge. That’s the whole point of the Code.

FAQs

Need HVAC help in Miami? Licensed & insured · within the hour response · free estimates
Call (850) 754-6042
Areas We Serve

Request a Free Estimate in Miami

Tell us what you need - Dalton Heating & Air Miami responds fast. No obligation.

By providing your information above, you accept our Privacy Policy and consent to being contacted by phone, email, or text about your request, including by the independent contractors we may refer it to.

Prefer to text? Text Now
Call Now - 24/7 Dispatch